Professional Networking Services

The network behind the security system

A camera, an alarm panel, or a door station is only as reliable as the network carrying it. Across the Phoenix metro we keep finding the same closet: a consumer router, one or two access points, and cable that was never labeled. Cameras drop offline in the afternoon, the alarm app times out, and the front desk blames the equipment. Most of the time the equipment is fine. The building was never wired for always-on video.

Block walls, metal roofs, and long warehouse aisles stop Wi-Fi cold. A louder router in the same closet does not reach a room the signal never entered. We walk the property, decide which runs should be Ethernet, and place access points where people and devices actually sit. Camera backhaul and links between buildings are almost always cable. Guest phones stay on their own network so they cannot reach the recorder, the point-of-sale system, or the alarm panel.

Who this is for

Offices and shops that hung cameras on a residential router. Warehouses with a dead zone between the office and the yard. Properties with more than one building that still share a single password written on a sticky note. Houses with a detached garage or casita where the camera feed dies every time someone streams a movie. If the security system cannot stay online, the network is part of the security job, whether the address is a storefront or a home.

How an install usually goes

We start with a walkthrough and mark where cameras, panels, desks, and outdoor coverage need a connection. Then we separate what must be wired from what can stay wireless. Cabling, a switch that can feed several video streams, and access points go in next. We set VLANs, replace passwords that match the brand printed on the router, and close remote access that was left open for convenience. Before we leave we test speed at the far corners, label every drop, and show you how to add a device without putting the recorder on the open internet.